• 1 1/16" - ID
• 1 3/16 - OD
• 1/2" Wide

This Is The Retaining / Snap Ring For The 20 / 30 Series Comet Torque-A-Verter Driven. It Was Also Used On Yerf-Dog Go-Karts. A Diagram Is Presented In The Photos.

Replacement push in retaining buttons used in 20 and 30 series torque converters on the driven pulley. Sold 3 to a pack. If you are replacing all six buttons order two packs.
For Part Replacement Numbers:

• Manco #6804
• 22575
• Comet #204332A

30 series torque converter driven pulleys. Plastic stops are Insert Button for 20, 30 & Torq-A-Verter  (requires 6)

• 011190A White Springs engage at 3100 RPM w/ Zinc Weights (stock)
• 011190A White Springs engage at 4000 RPM w/ Alum Die Cast

• 216111A Fluorescent Yellow engage at 3300 RPM w/ Zinc Weights (stock)
• 216111A Fluorescent Yellow engage at 4200 RPM w/ Alum Die Cast

• 216111A Blue/Silver Springs engage at 3600 RPM w/ Zinc Weights (stock)
• 216111A Blue/Silver Springs engage at 4600 RPM w/ Alum Die Cast

Blue spring, used on comet 20 series driven pulleys. Popular on Carter Brother's go karts

Center hub for 20 and 30 series driver units.

Gold Spring, Stiffest Driven Spring Available. Great For Off Road Riding.

Note: ONLY FITS BEARING STYLE AFTERMARKET CLUTCHES (Found ON Newer MB200's) WILL NOT FIT CLUTCH WITHOUT BALL BEARINGS!
This Is The Belt For Newer Style MB200 Mini Bikes.

• Asymmetrical
• length 28.32
• width 3/4"
• Made In The USA by same company that MFG Comet

Note: ONLY FITS BUSHING STYLE AFTERMARKET CLUTCHES (Found on Older Units Or Upgraded Clutches Such As Comet.) WILL NOT FIT CLUTCH WITH BALL BEARINGS!
Our Number 1 Selling TAV Replacement Belt. The Most Heavy Duty Belt Made In The Industry! Cheaper Than The OEM Belt. Made In The U.S.A. Great For Performance Bikes And Karts. Fully Tested And Endorsed By Team Studz And Many In The Detroit Area! Compatible With TAV 30-75 Torq-A-Verter, Comet After Market Clone, And Comet TAV2 Torque Converter. Fits MB200 And Any Torque Converter with 7' Center To Center Measurements.
Replaces 203589 / 5959

This is by far the best performance belt for a MB200 with a Juggernaut!!
Made by same MFG that makes them for Comet
Made in USA !!!

20 series-symmetrical, length 28.32" width 3/4".

Symmetrical belt , length 31.23", width 3/4"

Symmetrical, length 33.78, width 3/4"

Symmetrical, length 37.11", width 3/4"

Used on all Murray torque converter karts with Tecumseh engines. The Most Heavy Duty Belt Made In The Industry! Made In The U.S.A. Fully Tested And Endorsed By Team Studz And Many In The Detroit Area!

Asymmetrical, length 31.23", width 3/4"
Manco Part # 8192

Asymmetrical, length 33.78", width 3/4"

• 5/8" Wide

Used on all yerf-dog kart torque-converter karts with Tecumseh engines.
Asymmetrical, length 29.28", width 3/4"