Home > Performance Engine Parts > Hop Up Kits > Tillotson
Sort By:
Page of 1
Tillotson 212 Billet Flywheel And Billet Rod Combo Tillotson 212 Billet Flywheel And Billet Rod Combo

Superior High performance! Billet Aluminum Flywheel with integrated rare Earth magnet Delivers Hotter spark and advanced timing with 32 Degrees. Also comes With A Superior billet rod with bearings.
  • SFI certified billet aluminum flywheel for Tillotson 196/212 engines. Will work with stock pull rope and OEM coil. Weights 3.5lbs and has a special designed high-power magnet that creates a spark that is hotter and lasts longer, getting the most power from every drop of fuel. Flywheel is set at 32 degrees BTDC with a stock key. Minimum coil gap .030. Torque to 65 ft/lbs

  • Long billet connecting rod to use in 72mm block with either the 2.165" or the 2.205" crankshaft and our forged lightweight 72mm piston. With over an 1/8" longer center to center length then your standard clone or predator rod, this rod helps produce a tremendous amount of torque! When paired with the 2.165" crank and lightweight piston (138220047), the piston will be approximately .010" below deck. With the 2.205" crank and lightweight piston (138220047) the piston will have approximately .010" pop up.
This Combo is a must when removing governor!!

Our Price: $185.00
Tillotson 212 Electric Start Billet Flywheel And Billet Rod Combo Tillotson 212 Electric Start Billet Flywheel And Billet Rod Combo

For The Electric Start Tillotson Engine. Superior High performance! Billet Aluminum Flywheel with integrated rare Earth magnet Delivers Hotter spark and advanced timing with 32 Degrees. Flywheel Has A Pinion for The Electric Starter. Also comes With A Superior billet rod with bearings.
  • Billet aluminum flywheel for the electric start Tillotson. Built from 6061-T6 aluminum features a powerful rare earth magnet and a replaceable 7075-T6 aluminum ring gear. This SFI approved flywheel features 32 degrees BTDC timing (8 degrees advance) and high performance yet durable fin design. Also works with the OEM pull start. Will NOT accommodate the OEM charging system.

  • Long billet connecting rod to use in 72mm block with either the 2.165" or the 2.205" crankshaft and our forged lightweight 72mm piston. With over an 1/8" longer center to center length then your standard clone or predator rod, this rod helps produce a tremendous amount of torque! When paired with the 2.165" crank and lightweight piston (138220047), the piston will be approximately .010" below deck. With the 2.205" crank and lightweight piston (138220047) the piston will have approximately .010" pop up.
This Combo is a must when removing governor!!

Our Price: $300.00