Available in three thickness For Big Block And Small Block: .015", .030" .060" Please Make Sure Of What Size Block You Are Ordering For

Small Block: fits GX120, Briggs Animals, GX160s, etc.
Big Block: fits GX240/390, and 13hp Chinese OHV’s etc.

Note: Shim thickness may vary slightly.

Your Basic Throttle Stop Pin. Set Your Throttle and Tighten it down.

These Shims Are Used For Setting The End Play On Crank Shafts. Compatible With GX390 & 420 predators And Are Sold As EACH INDIVIDUALLY.
Made of Spring steel. Thickness are approximate and subject to manufacturing tolerances (typically -.05 to +0.0mm).

Available in

• .004" (.1mm)
• .008" (.2mm)
• .012" (.3mm)

These Shims Are Used For Setting The End Play On Crank Shafts. Compatible With GX200, 212 predators & BSP/AKRA Clones. These Are Sold As EACH INDIVIDUALLY.
Made of Spring steel. Thickness are approximate and subject to manufacturing tolerances (typically -.05 to +0.0mm).

Available in

• .004" (.1mm)
• .008" (.2mm)
• .012" (.3mm)

Sold Individually, Stock Replacement Lash Cap for Predator 212 And GX120 to GX200

Stock Oil Drain Plug. Fits Predator 212 and GX100, GX120, GX140, GX160, GX200, GXV120, GXV140 and GXV160. Replaces Stock Honda Part 90131-ZE1-000.

Stock Lash Caps. 5.5 mm Sold Each. For Hemi Predator, GX200 & 6.5 Chinese OHV's.

NGK Spark Plug Resistor Plug end 90 Degree. Water Proof.

(Sold Individually) Case Bearing For Chinese 6.5 OHV

2ft .070 Buna-n O-Ring for our 6052,6057 and 6058 Billet Sidecovers

• Specifically designed with colder heat ranges than the factory plug to enable performance modifications and handle intense conditions
• Contains an Yttrium-enhanced alloy to enable up to 8% reduction in sidewire temperature for improved durability and less pre-ignition
• Features cut back ground electrode for improved ignitability of flame kernel
• Coated in an anti-corrosive nickel plating to prevent rusting

Offset timing key used to advance timing on all Hondas and Chinese OHVs. 2, 4, 6, 8, & 12 degrees

Billet Guide Plate for use with Chrome Moly Push Rods For the GX200

Predator 212 .010 Thin Steel Head Gasket. 70mm 2.756

Clone GX200 Head Gasket 68mm 2.682

Clone GX200 .045 Fiber Fire Ring Head Gasket 68mm 2.682

Screw in Muffler for The Header/Exhaust Single Center Outlet For Screw On Muffler, GX200, GX160, 6.5 Chinese OHV, & 212 Predator Pipe

Small Block Valve Guide 6.5mm Stem size. Must be reamed or honed to size, Each (sold individually - 2 required per head)

Predator 212 .045 Fiber Fire Ring Steel Compression Ring Head Gasket.

Racing Valve Spring, 18lb closed pressure. Fits new style Predator (Hemi Head) engines.

Air Filter, Race, Open Element (K&N Type), Style may vary. Use with most 2 5/16 air filter adapters.

Billet Guide Plate for use with Chrome Moly Push Rods For the GX390

SPI Plug Resistor Plug end 90 Degree. Water Proof. Comes in 4 Colors